Software License Authentication - NEC UNIVERGE SV8300 Pc Programming Manual

Software License Authentication

Error Message
Activation Code couldn't be set.
PBX Generator File couldn't be
prepared.
Failed to back up the office data.
After a while, execute backup of
office data again.
The file specified is not existed.
Checksum error occurred.
FileFormat is wrong.
Select a file.
License data couldn't be regis-
tered.
License data couldn't be deleted. Deletion of license data reg-
Cause
The Activation Code could
not be registered on the
SV8300.
A PBX creation file could
not be created after license
data had been registered on
the Main Unit.
An Activation Code was reg-
istered on the SV8300 but
office data backup failed.
The specified file could not
be read.
Checksum error.
A wrong file has been speci-
fied.
No license data file has been
specified.
License data could not be
registered on the SV8300.
istered on the SV8300 was
attempted but failed.
C-16
Appendix C Troubleshooting
Remedial action
Check with the Software License
Authentication Center to see if
the Activation Code is valid and
then retry.
Check the size of available hard
disk drive space on the PC and
check to see if the folder proper-
ties are not configured to disable
writing.
Wait for a while and retry the
office data backup.
Select a license data file and
retry.
–
Select the right license data file.
Specify license data file and
retry.
Retry.
Retry.
NWA-033628-001 Rev.1.0