Huawei USG6000 Upgrade Manual page 141

HUAWEI USG6000&USG9500
Upgrade Guide
2.
3.
Preparing for the Environment for the Upgrade Through Web (HTTPS)
As shown in Figure 2, the USG9500 is configured as the Web server and the version software
is located on PC2. On PC2, log in to the USG9500 using the browser and then upload the
version software to the CF card of the USG9500 through Web.
To transfer PAF file to the CF card of the USG9500, you need to configure PC2 as the FTP
server so that the USG9500 can download PAF file and license file from PC2 as an FTP
client.
The Web service is enabled on the USG9500 by default. You can use the IP address
192.168.0.1 of interface GigabitEthernet 0/0/0 on the MPU and the default user name admin
and password Admin@123 to log in to the web UI of the USG9500 through HTTPS. If you
Issue 01 (2018-01-16)
the ACT indicator is on, the MPU is active. If the ACT indicator is off, the MPU is
standby.
Enter the system view and start the FTP service. Configure a user account with user
name ftpuser and password Admin@123, and specify the storage path of the FTP file.
This storage path must be cfcard:. You can use other user accounts as required.
V500R001:
[sysname] ftp server enable
[sysname]aaa
[sysname-aaa] manager-user ftpuser
[sysname-aaa-manager-user-ftpuser] password
Enter Password:
Confirm Password:
[sysname-aaa-manager-user-ftpuser] service-type ftp
Warning: The user access modes include Telnet or FTP, so security risks exist.
[sysname-aaa-manager-user-ftpuser] level 3
[sysname-aaa-manager-user-ftpuser] ftp-directory cfcard:/
[sysname-aaa-manager-user-ftpuser] quit
[sysname-aaa] quit
On PC2, log in to the FTP server to check whether configurations are effective.
The following uses the configuration of Windows FTP client as an example. In practice,
you are advised to use a legitimate third-party FTP client (such as Cute FTP) to transfer
files.
– Click Start and then Run. Enter cmd and then press Enter.
– Enter ftp 192.168.0.1. This IP address is used when you log in to the USG9500
through Telnet or SSH.
– Enter the user name after the User (192.168.0.1:(none)) prompt and the password
after the Password prompt.
The following information is displayed:
C:\> ftp 192.168.0.1
Connected to 192.168.0.1.
220 FTP service ready.
User (192.168.0.1:(none)): ftpuser
331 Password required for ftpuser.
Password:
230 User logged in.
ftp>
If 230 User logged in. is displayed on the FTP client, you have logged in to the FTP
server normally.
After the configuration is verified, you can either keep this connection for further use, or
exit from the FTP server and relog in to it when required.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 USG9500
132