Huawei USG6000 Upgrade Manual page 75

HUAWEI USG6000&USG9500
Upgrade Guide
Procedure
Step 1 Log in to the NGFW from PC2 using FTP. This document uses the Windows FTP client as an
example. In practice, you are advised to use a proven third-party FTP client (such as Cute
FTP) to transfer files.
The following information is displayed:
C:\> ftp 192.168.0.1
Connected to 192.168.0.1.
220 FTP service ready.
User (192.168.0.1:(none)): ftpuser
331 Password required for ftpuser.
Password:
230 User logged in.
ftp>
Step 2 Set the file transfer mode. Set the directory for saving upgrade-related files on PC2 to D:\FTP.
The folder must already exist. You can specify another directory as required.
ftp> binary
mode.
ftp> lcd D:\FTP /Set the directory that stores the files required for the upgrade
on PC2.
Step 3 Run the put command to upload the USG6000V500R001C80SPC100.bin file to the CF card
of the NGFW. The name of the file to be uploaded cannot be the same as the name of any
existing file in the CF card. If a file with the same name already exists in the CF card, the file
is replaced by the uploaded file.
ftp> put D:\FTP\ USG6000V500R001C80SPC100.bin
Depending on the network conditions, the upload of the version software may take some time.
Please wait. After the upload is complete, check whether the size of the file in the CF card is
consistent with that on PC2. If no, re-upload the file to ensure that the file is completely
uploaded to the CF card.
Convert the configuration file of the original version to that of V500R001C80SPC100. For
details, seeConfiguration Conversion.
Step 4 Run the put command to upload the configuration file that has been converted (for example,
vrpcfg_new.cfg) to the CF card of the NGFW. The name of the file to be uploaded cannot be
the same as the name of any existing file in the CF card. If a file with the same name already
exists in the CF card, the file is replaced by the uploaded file.
ftp> put D:\FTP\vrpcfg_new.cfg
After the upload is complete, check whether the size of the file in the CF card is consistent
with that on PC2. If no, re-upload the file to ensure that the file is completely uploaded to the
CF card.
Step 5 When the file upload is complete, exit the FTP environment. Log in to the CLI of the NGFW
through Telnet or SSH from PC1.
Step 6 In the user view, run the startup system-software filename command to specify the version
software for the next startup of the NGFW.
<NGFW> startup system-software
Info:System software for the next startup:hda1:/USG6000V500R001C80SPC100.bin,
Issue 01 (2018-01-16)
/Run the binary command to specify file transmission in binary
NOTICE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
USG6000V500R001C80SPC100.bin
1 USG6000
66