Device Serving As The Sftp Server To Upload Or Download Files Through Sftp - Huawei USG6000 Upgrade Manual

HUAWEI USG6000&USG9500
Upgrade Guide
After the uploading is complete, check whether the sizes of files on the TFTP server are the
same as those in the CF card. If no, re-upload the files to ensure that they are completely
uploaded to the TFTP server.
Step 4 Download files from the TFTP server to CF card of the USG9500.Run the tftp ip-address get
source-filename [ destination-filename ] command in the user view to download files from the
TFTP server.
<USG9500> tftp 192.168.0.2 get temp.cc
After the downloading is complete, check whether the sizes of files in the CF card are the
same as those on the TFTP server. If no, re-download the files to ensure that they are
completely downloaded to the CF card.
----End
2.5.3 Device Serving as the SFTP Server to Upload or Download
Files Through SFTP
Context
As shown in Figure 1, USG9500 serves as the SFTP server. Log in to the SFTP server from
the PC2 and upload/download files through SFTP. This method requires the third-party SFTP
client program (such as WinSCP) to be installed on the PC2.
Figure 2-21 Schematic diagram of uploading/downloading files through SFTP and with the
USG9500 serving as the SFTP server
Procedure
Step 1 Configure the SFTP client.Install the SFTP client program on PC2 and configure the SFTP
client using the document available with the program. Suppose that you obtain the SFTP
client program in a legitimate way and description of the program is beyond the coverage of
this document.
Step 2 Log in to the USG9500 from PC1 through Telnet/SSH.
Step 3 On the USG9500, create an SFTP user with user name user1 and password Admin@123 and
enable the SFTP server service.
Issue 01 (2018-01-16)
NOTE
You can also use a PC as both the Telnet/SSH client and the SFTP server. The following example
describes takes the two-PC deployment.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 USG9500
183