Huawei USG6000 Upgrade Manual page 153

HUAWEI USG6000&USG9500
Upgrade Guide
Step 2 Set the transmission mode of the file and configure the directory for storing the required
upgrade files as a directory on PC2, for example, D:\FTP. Note that the directory must
already exist. You can use another existing directory as required.
ftp> binary
transferring files.
ftp> lcd "d:\FTP" /Configure the directory on PC2 for storing the required
upgrade files.
The binary mode is required for file integrity, especially in the Linux or Unix system.
Step 3 Run the put command to upload USG9500 to CF card 1 of the USG9500.
ftp> put USG9520V500R001C80SPC100.cc
..........
ftp: 254711997 bytes sent in 192.90Seconds 970.68Kbytes/sec.
Uploading the system program may take a few minutes, depending on the network conditions.
Please wait patiently.
After the uploading is complete, check whether the size of the file in the CF card is the same
as that on PC2. If no, re-upload the file to ensure that it is completely uploaded to the CF card.
Step 4 Run the put command to upload the configuration file (such as vrpcfg_new.cfg) to the CF
card on the USG9500.The name of the file to be uploaded cannot be the same as the name of
any file on the CF card.If a file with the same name exists on the CF card, the file will be
replaced by the uploaded one.
ftp> put D:\FTP\vrpcfg_new.cfg
After the uploading is complete, check whether the size of the file on the CF card is the same
as that on PC2. If no, re-upload the file to ensure that it is completely uploaded to the CF card.
Step 5 Rename license_Secospace_X.txt to license_spcxxx.txt, and upload the file to the CF card 1
in the USG9500. If a file with the same name exists in CF card 1, the system displays a
message to indicate whether to overwrite the original file.
ftp> put license_spcxxx.txt
..........
ftp: 12757 bytes sent in 0.03Seconds 425.23Kbytes/sec.
Issue 01 (2018-01-16)
/Run the binary command to configure the binary mode for
CAUTION
NOTICE
NOTICE
NOTE
You can modify the names of the system program (*.cc), the PAF file, and license file. To ensure that
two software versions work on the same device, you are advised to modify the names of PAF and license
files and add the SPC version at the end of the file name, such as license_spcxxx.txt.
After the uploading is complete, check whether the size of the file in the CF card is the same as that on
PC2. If no, re-upload the file to ensure that it is completely uploaded to the CF card.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 USG9500
144