Checking The Running Status Of The Device - Huawei USG6000 Upgrade Manual

HUAWEI USG6000&USG9500
Upgrade Guide
IPS Update
Anti Virus Update

2.2.6.4 Checking the Running Status of the Device

Checking the CPU and Memory Usage
In any view, run the display health command to check the CPU and memory usage. If the
CPU and memory usage before and after upgrade differs slightly, it indicates that the device is
running normally.
<USG9500> display health
Slot
-----------------------------------------------------------------------
4 MPU(Master)
1 LPU
2 SPU-CPU1
2 SPU-CPU3
2 SPU-CPU6
Checking Session Statistics
In any view, run the display firewall session statistics command to check session statistics. If
the session statistics before and after upgrade differ slightly, it indicates that services are
running normally.
<USG9500> display firewall session statistics
Session Statistics:
Slot
Slot
Slot
Slot
Total 0 session(s) on all slots.
Checking Traffic Statistics
In any view, run the display interface interface-type interface-number command to check the
traffic statistics on a service interface. If the traffic statistics before and after upgrade differ
slightly, it indicates that services are running normally.
The following is sample output from this command on GigabitEthernet 1/0/2:
<USG9500> display interface GigabitEthernet 1/0/2
GigabitEthernet1/0/2 current state : UP
Line protocol current state : UP
Description:Huawei, FW Series, GigabitEthernet1/1/1 Interface
Route Port,The Maximum Transmit Unit is 1500
Internet Address is 101.1.1.2/24
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 0018-8239-1e5c
The Vendor PN is PLRXPL-VI-S24-HW
The Vendor SN is CE10QQ8VK
The Vendor Name is JDSU
Port BW: 1G, Transceiver max BW: 1G, Transceiver Mode:
MultiMode
Rx Power: -5.50dBm, Warning range: [-16.99,
Tx Power: -4.97dBm, Warning range: [-9.50,
Loopback:none, full-duplex mode, negotiation: disable, Pause Flowcontrol:Receive
Enable and Send Enable
Last physical up time
Last physical down time : 2016-01-28 13:56:19 UTC+08:00
Max input bit rate: 837731200 bits/sec at 2016-01-28 19:28:32
Max output bit rate: 96 bits/sec at 2016-01-28 14:23:09
Issue 01 (2018-01-16)
: Enabled; service expire time: 2023/04/24
: Enabled; service expire time: 2023/04/24
CPU Usage
7%
15%
82%
80%
2%
6 cpu 0: 0
6 cpu 1: 0
6 cpu 2: 0
6 cpu 3: 0
: 2016-01-28 14:12:56 UTC+08:00
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Memory Usage(Used/Total)
45% 772MB/1714MB
35% 293MB/820MB
17% 85MB/500MB
17% 85MB/500MB
14% 57MB/398MB
0.00]dBm
0.00]dBm
2 USG9500
Simulate CPU
None
None
0%
0%
None
165