Huawei USG6000 Upgrade Manual page 43

HUAWEI USG6000&USG9500
Upgrade Guide
The Web service is enabled on the USG6000 by default. You can use the IP address
192.168.0.1 of interface GigabitEthernet 0/0/0 on the USG6000 and the default user name
admin and password Admin@123 to log in to the web UI of the USG6000 through HTTPS. If
you have disabled the Web service or deleted the default user, do as follows to reconfigure the
service.
You can use only one PC on which you run both the Telnet/SSH client and the browser/FTP server. To
facilitate description, the network using two PCs is used as an example. The following steps apply to this
two-PC network.
Do as follows to configure the USG6000 as the Web server:
Procedure
Step 1 Log in to the USG6000 CLI through Telnet or SSH from PC1. For the Telnet or SSH login
method, see the related configuration example in
HUAWEI USG6000&USG9500 V500R001C80SPC100 Product Documentation
You are recommended to use interface GigabitEthernet 0/0/0 on the USG6000 for log in. By
default, the IP address for interface GigabitEthernet 0/0/0 is 192.168.0.1, the user name is
admin, and the password is Admin@123.
Step 2 Enter the system view and start the Web service. Configure a user with user name webuser
and password Admin@1234 and the level of the Web user. You can use other user names and
passwords as required.
<FW> system-view
[FW] web-manager enable
[FW] web-manager security enable port 8443
[FW] aaa
[FW-aaa] manager-user admin
[FW-aaa] service-type web telnet ssh
[FW-aaa-manager-user-admin] level 15
[FW-aaa-manager-user-admin] password cipher Admin@1234
Please input old password
Info: You are advised to config on man-machine mode.
Info:Total 2
cut.
manager-user-admin]
Info: Receive a message from AAA of cutting user.
User interface con0 is available
Please Press ENTER.
Login
authentication
Username:admin
Password:
[FW] interface GigabitEthernet0/0/0
[FW-GigabitEthernet0/0/0] service-manage enable
[FW-GigabitEthernet0/0/0] service-manage http permit
[FW-GigabitEthernet0/0/0] service-manage https permit
[FW-GigabitEthernet0/0/0] quit
Step 3 On PC2, configure an IP address in the same network segment as GigabitEthernet 0/0/0. Log
in to https://192.168.0.1 using the Internet Explorer on PC2 to verify the configurations.
Issue 01 (2018-01-16)
NOTE
user(s) being
<FW> system-view
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 USG6000
[ FW-aaa-
34