Removing The Cdp Control Panel - ABB ACS5000 User Manual

10.4. Removing the CDP control panel

When the CDP control panel must be removed from its mounting cradle, follow the
instructions below.
1. When the panel is removed while the drive is in operation, check the setting of
parameter 31.01 PANEL LOSS SUPERVISION first.
If the parameter is set to NOT USED, the panel can be removed without
interrupting drive operation.
For more information on parameter settings, see "Appendix G - Signal and
parameter table".
2. To remove the panel, proceed as illustrated.
IMPORTANT! When the CDP control panel has been removed during operation,
the drive can only be stopped by pressing the emergency-off pushbutton.
1
LEDs
The green LED (4) signals that the control voltage has been switched on.
Communication with AMC circuit board
The CDP control panel (1) is connected to the AMC circuit board (2) via an RS485
interface.
1
ACT PAR FUNC DRIVE
I 0
PRODUCT
ACS5000W
2
2
DOCUMENT KIND
User manual
PREVENTIVE AND CORRECTIVE MAINTENANCE
3
4
DOCUMENT ID.
3BHS799208 E01
REV. LANG. PAGE
F en 160/178