Set Up Connection To A Dicom Server In A Network - GE Vivid i n Service Manual

GE H
EALTHCARE
D FQ091013, R
IRECTION
3-10-4

Set Up Connection to a DICOM Server in a Network

In this case, the Vivid i n/ Vivid q N is configured to work with a DICOM server in a network environment.
Images are first saved on the local image buffer on the scanner. At the end of the examination, the
images are sent to the DICOM server via a DICOM spooler.
This scenario requires that the scanner is configured to be connected to the DICOM server as described
below.
3-10-4-1 Overview
To work against the DICOM server, the following information has to be entered in the scanner:
• DICOM server IP address, subnet mask and eventually the gateway.
• DICOM server port number.
• DICOM server AE title (the server application's name).
• Name of Device.
3-10-4-2 DICOM Server IP Address Setting on the Scanner
1.) Press CONFIG (F2) and log on as Adm, as described in
2.) Select CONNECTIVITY (in the lower part of the window).
3.) Select the DATAFLOW tab.
4.) Select the arrow to the right of the Name field to list all dataflows in a pull-down menu, see
Figure
5.) From the Dataflow Name pull-down list, select the dataflow you want to configure - see
3-115.
3-110
1
EVISION
3-115.
Figure 3-115 Select Dataflow
Section 3-10 - Connectivity Setup
V V
IVID I N AND IVID Q
Log On to the System as ADM on page
Arrow
Select dataflow from
Dataflow Name pull-down
menu.
N S M
ERVICE ANUAL
4-10.
Figure