Installing Software Only Or Patch - GE Vivid i n Service Manual

Hide thumbs Also See for Vivid i n:

Table of Contents

Installing Software only or Patch

IMPORTANT It is recommended to store partition C:\ by using the Rollback tool (described in the

Software Roll-back Procedure on page 8 -

1) Connect the DVD\CD-RW to the system's USB port.

2) Connect the DVD\CD-RW power supply to the mains power.

3) Place the CD with Patch or Software Only CD into the tray and close.

4) Turn ON the system.

During boot-up, system will prompt to install software or continue booting into regular mode.

5) Click on Install Software and follow the on-screen instructions.

6.) When done, the Installation Complete message is displayed (refer to

7) Move the cursor over the displayed message window and press the SET button.

8.) Press any key to re-boot the system.

The system re-boots into Normal Scanning mode.

9.) Press Config and then About.

The newly-installed software version is now listed under the System Version tab (refer to

Figure 8-130 on page

10.)Remove the CD from the DVD\CD-RW drive and close the tray.

11.)Proceed to perform the following functionality tests:

Calibration Tests on page 7 - 25

Full System Test on page 7 - 10

Software Configuration Checks on page 4 - 37

Calibration Tests on page 7 - 25

Full System Test on page 7 - 10

Section 8-5 - Software Loading

IVID I N AND

139) after full software installation or upgrade.

Figure 8-129 on page