Speaker Assembly Replacement Procedure - GE Vivid i n Service Manual

Hide thumbs Also See for Vivid i n:

Table of Contents

Speaker Assembly Replacement Procedure

This section describes the replacement procedure for the Speaker Assembly which is supplied as part

of the Fans and Speaker Kit - Part No. 2412826.

Use the appropriate flat and Phillips-type screw drivers, a wire cutter and the appropriate Hex wrench

keys as indicated in the speaker replacement procedure.

Time Required

Shut down the Vivid i n/ Vivid q N ultrasound unit, as described in - System Setup.

Speaker Assembly Removal Procedure

1) Remove the bearing handle, as described in the

2) Remove the Control Panel and Keyboard, as described in the

Removal Procedure on page 8 -

3) Loosen and remove the two screws on each of the speaker housings (four in total).

4) Disconnect the speaker cables from the fan assembly.

5) Gently lift the speaker assembly towards you and remove from the system.

Speaker Assembly Installation Procedure

1) Return a replacement speaker assembly to the original position, ensuring that the two connection

legs of each speaker are facing the two connection legs of the opposite speaker, otherwise an

electrical short may occur.

2) Reconnect the speaker cables to the fan assembly.

3) Return and fasten the two screws on each of the speaker housings (four in total), previously

4.) Proceed to perform the following functionality tests:

SafeLock Cart - Grounding Continuity on page 10 - 23

is currently mounted on the SafeLock cart

SafeLock Cart - Chassis Current Leakage Test on page 10 - 25

Calibration Tests on page 7 - 25

Full System Test on page 7 - 10

Speakers Tests on page 4 - 23

Section 8-3 - Internal Component Replacement Procedures

Bearing Handle Removal Procedure on page 8 -

IVID I N AND

Control Panel and Keyboard

- only if the Vivid i n/ Vivid q N system