Bep Replacement Procedure - GE Vivid i n Service Manual

Hide thumbs Also See for Vivid i n:

Table of Contents

BEP Replacement Procedure

INCREMENTAL BACK-UP OF THE ARCHIVE AND USER PRESETS

For details, refer to

Preparation on page 8 -

Use the appropriate Phillips and flat screw drivers, as indicated in the BEP replacement procedures.

Time Required

Preparations

Shut down the Vivid i n/ Vivid q N ultrasound unit, as described in - System Setup.

BEP Removal Procedure

1) Disconnect any peripherals currently connected to the system and make sure there is no T-plug

(dongle) or any other peripheral connected to the USB or PCMCIA.

2) Remove the bearing handle, as described in the

3) Make sure the Vivid i n/ Vivid q N LCD Display cover is securely closed and place the scanner face

down. Remove the battery as described in the

4) Remove the Hard Disk, as described in the

5.) Loosen and remove the two securing nuts (one on each side of the VGA Connector, located on the

Vivid i n/ Vivid q N rear panel), as shown

6) Remove the Control Panel and Keyboard, as described in the

Removal Procedure on page 8 -

7) Disconnect all the cables from the BEP.

Note: When replacing the BEP or Hard Disk, one must either obtain new access codes that will fit the

system ID which is programmed on the BEP, or program the BEP system ID to fit the access

codes already registered in the Hard Disk. Only qualified personnel should perform these tasks.

Proceed as follows:

Disconnect BEP cables as follows (refer to

a.) Disconnect the LCD Flex ribbon cable (carefully pull back the two connector latches to

BEFORE REPLACING THE BEP, REMEMBER TO PERFORM A FULL

Vivid i n Software Upgrade from Version BT10 to BT11 on page 8 - 98

Figure 8-45 Vivid i n/ Vivid q N Scanner - Rear View

Section 8-3 - Internal Component Replacement Procedures

Bearing Handle Removal Procedure on page 8 -

Battery Removal Procedure on page 8 -

Hard Disk Removal Procedure on page 8 -

Remove Securing Nuts

IVID I N AND

Control Panel and Keyboard