Table of Contents
Advertisement
GE H
EALTHCARE
D
FQ091013, R
IRECTION
8-7-2
External USB Hard Disk Replacement Procedure
NOTE:
This procedure is only applicable to Vivid i n/ Vivid q N systems mounted on the SafeLock Cart
NOTE:
This section describes removal and replacement procedures, including initial configuration.
8-7-2-1
Tools
Appropriate flat screwdriver and open-ended wrench.
8-7-2-2
Time Required
15 minutes
8-7-2-3
Preparations
Shut down the Vivid i n/ Vivid q N ultrasound unit, as described in - System Setup.
8-7-2-4
External USB Hard Disk Removal Procedure
NOTE:
Ensure that there is no activity on the drive before you turn it off.
If power is turned off while files are being written to the drive, the files will be corrupted.
1) Switch OFF the power to the unit.
The power switch is located at the rear of the unit - see
2) Disconnect the AC Power cable (connected between the power supply and the SafeLock Cart) from
the SafeLock Cart AC power outlet.
3) Disconnect the External USB Hard Disk from the USB port on the Vivid i n/ Vivid q N system.
4) Remove the unit.
NOTE:
If the External USB Hard Disk is filled with data, store it in a safe place and label it with the date, and a
note that the drive is full.
8-150
1
EVISION
Figure 8-150 External USB Hard Disk
Section 8-7 - Peripherals
V
V
N S
IVID I N AND
IVID Q
Figure 8-151 on page
8-151.
M
ERVICE
ANUAL
Advertisement
Table of Contents
