Installing Software Only From Dvd - GE Vivid i n Service Manual

Hide thumbs Also See for Vivid i n:

Table of Contents

Installing Software only from DVD

During software installation, all peripherals should be removed - including PCMCIA devices (but

excluding the DVD\CD-RW driver).

IMPORTANT It is recommended to store partition C:\ by using the Rollback tool (described in the

Software Roll-back Procedure on page 8 -

1) Connect the DVD\CD-RW to the USB port at the rear of the system.

2) Connect power to the DVD\CD-RW drive.

3) Place the DVD containing the full software version into the DVD\CD-RW drive and close the tray.

4) Turn ON the Vivid i n/ Vivid q N system and allow it to boot-up from the DVD.

The system powers ON and when system boot-up from the DVD is complete, the following options

are displayed in the DOS screen, prompting you to select the required option:

5) Press 2 to perform installation of Vivid i n/ Vivid q N Application Software only from DVD.

The system will continue to boot up and the following screen is displayed.

Section 8-5 - Software Loading

IVID I N AND

139) after full software installation or upgrade.