Accessing The Full System Diagnostic Options - GE Vivid i n Service Manual

Hide thumbs Also See for Vivid i n:

Table of Contents

Accessing the Full System Diagnostic Options

In 2D-Mode, press <ALT +Config> on the alphanumeric keyboard. The Diagnostic Test window is

displayed, as shown in

Full System Test (FE and BEP)

For a description of this test, refer to the

The Full System Test (FE and BEP) performs a full sequence of complete system tests (automatically)

and requires approximately 10 minutes for completion.

1.) In the Diagnostic Test window, trackball to Full System Test (FE and BEP) in the list of tests

available for selection from the Diagnostic Test Tree (see

System Test (FE and BEP) name is displayed under Execute, and all system components are

highlighted blue in the Schematic View, as shown below:

2.) As indicated in the Special Instructions area, make sure the system is calibrated and disconnect

any probe currently connected to the system.

3.) Under the Special Instructions area, activate the Loops checkbox

and select the required number of Loops from the combo box.

4.) Adjacent to On Fail, select either Stop or Continue, as required.

Stopping on failure enables you to review a failed test, the moment it fails. Alternatively, you may

Figure 7-5 Full System (FE and BEP) Test

Section 7-3 - Performing Full System Diagnostics

Full System Test (FE and BEP) on page 7 -

IVID I N AND

below) and press Set. The Full