Dta Configuration (Rf Port); Figure 6-8 - Dta Rf Port Configuration - Motorola APEX1000 Installation And Operation Manual

DTA Configuration (RF Port)

To continue configuring DTA support, click one of the RF Port folder tabs.
The corresponding DTA RF Port Configuration screen (RF 1–6) displays:
RF 1 through RF 6 represent the 48 QAM channels available, in increments of eight per
RF port. You can configure the following Network PID parameters (per RF Port) in the
DTA RF Port Configuration screen:
Parameter
Multicast IP
Source IP
Configuration • DTA Support Overview
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
Figure 6-8 — DTA RF Port Configuration
Description
IPv4 address to receive PID stream.
Range: Multicast IPv4
The default is 0.0.0.0
0.0.0.0 indicates Unicast stream.
IPv4 address of multicast source.
Range: Multicast IPv4
The default is 0.0.0.0
0.0.0.0 indicates that SSM is not used.
B
89