Table of Contents
Advertisement
Error Code
Reference Number Error Description
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
Status • Reports
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
Primary is already in use for a different type of routing
Pass Thru Enable set to invalid value
Service Enable set to invalid value
PID Enable set to invalid value
Source Specific IP cannot be assigned to this MC IP
Source Specific IP already assigned, non-zero Src IP not allowed
Output is not in required operating mode for usage
Invalid pre-encryption setting
Invalid input program number
Invalid output program number
Input program number 0 cannot be mapped, already mapping from input
Input program number already mapped to output
Input program number 0 is mapped from input, no other mappings allowed
Output program number is already in use (already mapped)
Invalid input PID number
Invalid output PID number
Output PID already in use
Duplicate output PID mapping
Duplicate input PID mapping
Output PID not in valid range (PID remapping only)
CAT PID can only be remapped to CAT PID value
Input and output PIDs not the same (PID remapping disabled)
Input PID already in use (mapped to same output)
Primary interface port number out of range
Primary interface port not enabled
Primary UDP port is invalid
Primary MC invalid
B
243
Advertisement
Table of Contents
