Motorola APEX1000 Installation And Operation Manual page 327

•
Reset APEX1000 EM Username and Password — Provides the ability to reset the
current username and password to the factory default values.
•
Save Changes — Preserves changes from RAM to flash. This allows the changes to
take effect on the next reboot.
•
Reboot Now — Causes the APEX1000 to reboot immediately; changes in RAM not
persisted to flash are discarded.
Show Enet1 Parameters Menu (Root.1)
Provides immediate display of the APEX1000 MAC address and ENET1 parameters.
Note: The actual addresses displayed are network dependent.
Eth1 IP Parameter Display
Configuration Method: IP configuration via BOOTP
protocol
Default IP address: 168.84.247.109
Default Subnet Mask: 255.255.0.0
Default Gateway: 168.84.247.1
Enet1 IP Setup (Fixed Config) Menu (Root.2)
This menu allows you to configure ENET1 with a fixed IP address and configuration.
From this menu you can access:
•
Set IP address — specifies the IP address for ENET1.
•
Set Subnet Mask — specifies the subnet mask for the network to which ENET1 is
attached.
•
Set Gateway IP — specifies a computer/server that will act as a gateway to other
network segments.
•
Save Changes — preserves changes from RAM to flash. This allows the changes to
take effect on the next reboot.
•
Reboot Now — causes the APEX1000 to reboot immediately; changes in RAM not
persisted to flash are discarded.
Enet1 IP Setup (via boot protocols) Menu (Root.3)
This menu allows you to select a boot protocol, which is used to obtain an IP address
and configuration at boot time. From this menu you can access:
•
Do not use boot protocols — Causes the APEX1000 to use the fixed IP
configuration specified in the previous menu. This selection cannot be made if the
APEX1000 configuration files or application files have been purged.
•
Use Bootp to obtain config — Causes the APEX1000 to send a BOOTP request at
boot. If a BOOTP reply is received, the APEX1000 will use the IP configuration
assigned by the BOOTP server.
Appendix F • RS-232 Test Console Port
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
B
309