Motorola APEX1000 Installation And Operation Manual page 155

Item
Index
Enable
Input Interface
Input UDP Port
Multicast IP
Source IP
Input Program
Output Program
Pre-Encrypt
Source ID
Provider ID
Service Error
Manual Routing • Program Mapping
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
Program Mappings window field definitions
Definition
Identifies the window line item.
Indicates that the particular route is enabled.
Specifies a GigE port (1 – 4) or Host port (1 – 2) as the input interface.
Specifies the input UDP port number for the transport stream. The input UDP Ports
must be in the following range:
•
GigE UDP Ports: 0 – 65535
•
Host UDP Ports: 1024 – 65535
Specifies the Multicast IP address. (You MUST enter this value, if applicable.)
•
Valid Range: 224.0.1.0 – 239.255.255.255
•
Reserved: 224.0.0.0 – 224.0.0.255
•
Not used: 0.0.0.0
This is the IP address of the source device for multicast reception. The source IP
address must be a valid singlecast address. (You MUST enter this value, if
applicable.)
Only applicable when using multicast on a network that supports IGMP v3.
Identifies the input MPEG program number for the transport stream (0 – 65535).
Input Program No. 0 is used as a wild card program. This informs the APEX1000 to
map the first service listed in the input PAT message to the specified output.
When mapping a program using input program number 0, only one service mapping
from that specific input to an output can be performed.
Identifies the output MPEG program number for the transport stream (1 – 65535).
A check mark indicates that the input service may be pre-encrypted. This informs
the APEX1000 to check each input service for a CA ECM descriptor (in the PMT).
Any input service that contains a PMT with a CA ECM descriptor is considered to
be pre-encrypted. The CA ECM descriptor is checked at both the program level and
component level. The APEX1000 will process the service as normal, but also will
pass-through the ECM PID. (The APEX1000 can support only pre-encrypted
services when the ECM and PMT PIDs are on separate input PIDs.)
Note: Only applicable when the encryption mode for the output is None or CTE (not
Broadcast encryption).
16-bit source ID to be used for Broadcast encrypted services. Use in conjunction
with the Provider ID to identify a service to be mapped.
See Source ID and Provider ID
Provides a count of the number of services in error on the current output, and alerts
you when a new mapping is in error.
for more information.
B
137