Motorola APEX1000 Installation And Operation Manual page 198

Confirming RPC Configuration
You can use the following screens to verify RPC operation on the APEX1000:
•
SDV > RPC Status — Provides route information, including source IP, UDP port,
program numbers, and bandwidth used.
For more information, reference
•
SDV > RPC QAM Status — Provides status on each QAM, including the number of
active sessions and the bandwidth allocated to them.
For more information, reference
RTSP/MHA Mode-Specific Configuration
These parameters establish communication with the controller and inform the controller
of the APEX1000 interfaces. To configure an RTSP or MHA session, you must first
configure the APEX1000 with GigE input information and QAM output information. (The
RTSP controller interface is configured last.)
CAUTION This process assumes that the RTSP controller is already configured and operating
correctly.
Configuring GigE Input Groups
Use the RTSP GigE Group Configuration window to configure the GigE inputs which are
reported to the session controller.
To open this window:
1. Select SDV > RTSP GigE Group Configuration from the top menu
or
2. Click Edge Configuration on the RTSP Controller Configuration window and select
RTSP GigE Group Configuration:
Configuring for Switched Digital Video • Step by Step Instructions
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
RPC Status.
RPC QAM Status.
B
180