Motorola APEX1000 Installation And Operation Manual page 74

Downloaded File Names
The downloaded configuration files do not use the same names as the original released
configuration files. The following list shows the names as they are stored on the
APEX1000:
•
config.ini
•
bcmr.ini
PID mapping, and stream pass-through mappings.
•
sdv.ini
•
gige_red.ini
configuration settings.
You can download these files and then load them onto the same (or a different)
APEX1000 using BOOTP. This makes it possible to quickly configure another APEX1000
in a similar manner.
CAUTION Although you can edit these files, it is not recommended that you do so. Loading a
corrupted configuration file onto an APEX1000 unit forces you to reconfigure the unit
through the EM, as most (or all) configuration settings will be lost. In the event that you
decide to edit these files, then use WordPad instead of Notepad. Notepad will corrupt
these files and cause them to be unusable when loaded onto an APEX.
Displaying the Current EM Version
To display current EM version information and build date:
1. Select System > About to activate the About pop-up.
2. Click Close to exit the dialog.
Ending a Session
To terminate a session, select System > Exit.
The EM application window closes; no further steps are required to end a session.
System Settings • Common System Tasks
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
— Same as apex1000.ini file, it contains all main configuration items.
— Same as apexbcmr.ini file, it contains all Manual Routing, Ancillary
— Same as apexsdv.ini file, it contains all SDV configuration settings.
— Same as apexred.ini file, it contains all GigE redundancy
B
56