Table of Contents
Advertisement
Item
Input Source
Time Logged
Pri/Sec
Severity
Description
Input Stream Status
The Input Stream Status window can help you determine where GigE ports are used, by
reporting the input UDP port data and/or stream rate of all GigE input streams in use.
The input stream rate is calculated by counting the number of MPEG packets received
over a five second status period. The rate is then calculated by converting the MPEG
packet counts into Megabits per second (Mbps).
Status • Reports
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
Definition
This is the IP address of the source device for multicast reception.
The source IP address must be a valid singlecast address.
Displays the time when the event was logged.
Specifies if the event involves the Primary or Secondary TS.
Indicates the severity of the event.
Provides a text description of the event, as shown in the example below:
Figure 12-18 — Input Stream Status
B
247
Advertisement
Table of Contents
