Mapping Error Log; Figure 12-16 - Mapping Errors Window - Motorola APEX1000 Installation And Operation Manual

Mapping Error Log

All Program Mappings and Ancillary PID Remapping errors are registered in the Mapping
Errors log window:
Item
Time Logged
Error Code
Mapping Type
TS:QAM
Input
Multicast
Source
Mapping
Status • Reports
APEX1000 All-Purpose Edge QAM Software Version 2.4.x • Installation and Operation Manual
573408-001-a
Figure 12-16 — Mapping Errors window
Mapping Errors window field definitions
Definition
Displays the date, time, and the time zone that the error was logged.
Displays a numerical value error code that corresponds to the fault condition. See
Error Codes for a complete listing of possible error conditions.
Displays the mapping type. Types: Program, Ancillary PID
The Output Transport Stream numbers (1 – 16, 17 – 32, 33 – 48) and Output QAM
channel.
Number of the input type from which to obtain data (GigE 1 – 4 or Host 1 – 2).
The Multicast receive IP address:
•
Valid Range: 224.0.1.0 – 239.255.255.255
•
Reserved: 224.0.0.0 – 224.0.0.255
•
Not used: 0.0.0.0
This is the IP address of the source device for multicast reception.
Displays the mapping range in->out.
B
Mapping
241