Print Head Alignment (Manual) - Epson ML-13000 User Manual

ML-13000 User's Manual
D
Touch Start.
Auto adjust starts, and an adjustment pattern is printed. Wait until adjustment is complete.
If banding or graininess is observed in the print result even after performing Automatic Adjustment, perform
fabric feed adjustment during printing.
"Changing settings while printing" on page 29
U
Note:
If the print results do not improve even by performing Print Adjustments, Fabric Feed Adjustment, and print head
alignment while printing, and if you notice one or two areas that have streaks or unevenness after printing 4 m (one
rotation of the belt), you may be able to improve the print results by adjusting the belt feeding motor. Contact our
qualified service personnel for more details.
When an error occurs during Automatic Adjustment
See the following for more details.
❏ Are the Print Width and Print Start Position set correctly?
If these settings are incorrect, the pattern will be printed on the belt and reading the pattern may fail. Start
over from step 2.
❏ Is the fabric clean?
If the fabric is dirty, reading the pattern may fail. Make sure that the pattern printing position is clean, and
start over from step 1.
If the error continues to occur even after checking the above, perform Manual from Print Head Alignment and
Manual from Fabric Feed Adjustment.
"Print Head Alignment (Manual)" on page 136
U
"Fabric Feed Adjustment (Manual)" on page 138
U

Print Head Alignment (Manual)

Landing site displacement is adjusted while printing the pattern.
You can select between Manual(Simple) and Manual(Details) adjustments.
Manual(Simple)
Select this option when you want to make a quick and simple adjustment by visually inspecting the pattern.
Manual(Details)
Select this when you want to perform adjustment equivalent to Auto Adjustment by visually inspecting the pattern.
A
Check that the printer is ready, and load the fabric according to the actual usage conditions.
B
From the menu screen on the control panel, touch General Settings - Printer Settings to set the Print
Width and Print Start Position.
Basic Operations
136