Inspecting/Cleaning The Sensors - Epson ML-13000 User Manual

ML-13000 User's Manual

Inspecting/Cleaning the Sensors

Inspection method
Confirm that the roll diameter measurement sensor and the side of the slack detection sensor on the rear of the
machine are lit up red, and that the lamp on top of the sensor is lit up green. If the lamp is lit up in orange, an
obstruction has been detected. Remove any obstructions from the sensor's optical axis.
A
Roll diameter measurement sensor
B
Slack detection sensor
C
Red light of the roll diameter measurement sensor
D
Green light of the roll diameter measurement sensor
E
Green light of the slack detection sensor
F
Red light of the slack detection sensor
If the sensors are dirty, clean the sensors and the reflector plates opposite the sensors using cleaning cloths or the
like.
"Inspecting/Cleaning the Sensors" on page 170
U
If the sensors do not respond well even after cleaning the sensors and the reflector plates, or if the lamp on top of
the sensor is lit up in orange after removing an obstruction, reset each of the sensors.
"Slack Detection Sensor and Roll Diameter Measurement Sensor" on page 146
U
Maintenance
170