Supply Status Menu - Epson ML-13000 User Manual

ML-13000 User's Manual
Item
Print Head Nozzle Limi-
tation
Replace Waste Ink Bottle
Replace Maintenance
Parts

Supply Status Menu

Item
Ink/Waste Ink Bottle
Others
Control Panel Menu
Parameter Description
On Set the print heads to use for printing.
For example, if there is a clogged nozzle in one print head and the clog
*
cannot be cleared after repeated head cleaning, you can continue
Off
printing using the unclogged print head. Use this when you want to
solve the problem without interrupting the printing work.
❏
❏
Confirm the check pattern printed by Print Head Nozzle Check, and
then select the print head that is not clogged.
Using the Print Head Nozzle Limitation function may increase the print
time and cause print quality to decline. Also, printing a Fabric Edge
Nozzle Check Pattern is disabled. We recommend using it only during
the time until the clogged nozzles can be cleared.
If you are replacing the waste ink bottle before the message indicating
that it is time to replace the waste ink bottle appears on the control
panel's screen, do so from this menu.
Replace Wiper Roll Start replacing the selected parts. Follow the on-screen instructions to
replace them.
Replace Cleaning
"Replacing the Wiper Roll" on page 212
U
Pad
"Replacing the Cleaning Pad" on page 219
U
Replace Flushing
"Replacing the Flushing Pad" on page 216
U
Pad
"Replacing the Washing Scraper" on page 224
U
Replace Washing
"Replacing the Sponge Roller" on page 227
Scraper U
Replace Sponge
Roller
Parameter Description
Shows the replacement timing, remaining amount and part number of
the selected consumables.
Wiper Roll
Washing Scraper
Sponge Roller
Adding Grease to
the Scan Spindle
When maintenance that takes time, such as Print Head Refresh,
needs to be done, do that maintenance after finishing work.
When the print head needs to be replaced, continue work until it is
replaced.
362