Problems With The Belt - Epson ML-13000 User Manual

ML-13000 User's Manual
E
Check the message and press OK.
Resume printing.
"Installing the Fabric Roll" on page 60
U
If the same error continues to occur after re-starting printing, repeat the procedure and use scissors to cut
and remove any floating or wrinkled areas of fabric in step 3.

Problems with the Belt

The belt loses adhesiveness after about a week, even after reapplication of
glue
The ink may have penetrated through to the back of the fabric and adhered to the belt, reducing the adhesive
strength of the glue on the belt. Remove ink stuck to the belt.
"Removing ink film" on page 282
U
Check and address the following to prevent ink from adhering to the belt.
Is the Ink Amount excessive?
o
Review the settings to adjust the ink input ejection amount. When using Epson Edge Print, adjust the Ink Amount in
(Basic Settings) in the Job Settings menu. For details, see the help for Epson Edge Print.
Are the concentrations of the treatment liquid and density enhancer liquid appropriate?
o
Review the settings for ink density adjustment. When using Epson Edge Print, adjust from
Job Settings menu. For details, see the help for Epson Edge Print.
Is Belt Cleaning on the control panel turned Off while printing?
o
When printing, turn On Belt Cleaning from Printer Settings on the control panel.
Are you printing outside of the fabric?
o
See below for how to prevent the print position from going beyond the fabric.
"The print is not positioned properly on the fabric" on page 373
U
Problem Solver
375
(Ink Adjustment) in the