Table of Contents
Advertisement
ML-13000
User's Manual
A
Button
C
Press the button again.
The light changes back to green and the sensor has been reset.
If the orange lamp flashes, the reset has failed. Remove any obstructions from the sensor's optical axis, and
then check that the light from the sensor is hitting the reflector plates. If the problem persists, contact our
qualified service personnel.
Fabric Floating Sensor
"Setting the Fabric Floating Sensor" on page 93
U
Tangled Fabric Detection Sensor
The machine will come to an emergency stop if the sensor detects that the printed fabric is caught in belt cleaning.
The sensor also detects water droplets and dust, so make sure you remove any that adhere to the belt.
After opening and closing the belt cleaning unit, the sensitivity of the sensor may change, so make adjustments if
errors occur frequently. Follow the steps below to adjust the sensitivity of the sensor.
Basic Operations
148
Advertisement
Chapters
Table of Contents
