Work After Glue Application - Epson ML-13000 User Manual

ML-13000 User's Manual
❏ Both ends of the belt
Make sure there is no glue or tape adhering to both ends of the belt.
Adhesion of the same may prevent the normal measurement of the belt feed rate. Remove the tape or wipe the
glue clean with a cloth soaked in an appropriate amount of ethanol.

Work after glue application

Clean the belt and prepare for printing.
A
After leaving it for 10 hours or more, peel off the insulating tape.
Worker 1: Peel the end of the insulating tape and hold it as you peel the tape from the belt.
Worker 2: Press and hold the Feed button on the front panel to slowly rotate the belt in the forward
direction.
Peel the insulating tape on the opposite side in the same way.
B
Check that Lift Up is displayed in Belt Cleaning Tank on the Home screen on the control panel.
When Lift Up is displayed, you can pull out the belt cleaning tank.
When Set Down is displayed, touch the display area and lower the cleaning tank.
Maintenance
339