Entering Adhesive Material Maintenance Application Mode - Epson ML-13000 User Manual

ML-13000 User's Manual
Work environment conditions
❏ Avoid work in high-temperature, high-humidity environments. The glue might not be applied evenly, resulting
in water droplets remaining after belt cleaning.
❏ Work in an environment that is clean and dust-free (meaning dust does not accumulate for 5 to 10 minutes
after cleaning).
Note:
❏ The belt rotation speed can be adjusted using the Belt speed dial on the front panel.
We recommend setting the belt rotation speed to a somewhat slower speed if this is your first time performing work.
❏ You also need to perform product curing when applying glue. See the following for more details.
"Product curing" on page 299
U
Workflow
1. "Entering Adhesive Material Maintenance Application Mode" on page 319
2. "Product curing" on page 320
3. "Check belt surface" on page 320
4. "Belt curing" on page 320
5. "Installing the blade" on page 324
6. "Ensuring safety" on page 331
7. "Glue preparation" on page 331
8. "Applying Glue" on page 332
9. "Blade removal and cleaning" on page 335
10. "Drying the glue" on page 337
11. "Work after glue application" on page 339
You can watch a video of the procedure on YouTube.
https://support.epson.net/p_doc/94e/

Entering Adhesive Material Maintenance Application Mode

Switch the printer to maintenance mode.
If you want to continue from the glue removal process, see step 3 and on.
Maintenance
319