Preparing The Felt - Epson ML-13000 User Manual

ML-13000 User's Manual
C
Touch Removal Mode - Start.
When you touch Forward or Reverse once on the control panel, the belt will continue to rotate until you
touch Suspended.
Touch Done to exit Removal Mode and return to the mode selection screen.

Preparing the Felt

Prepare some felt to soak up the ink film remover.
When using the felt that comes with the machine
A
Put the felt rod through the glue-removal felt.
When using commercially available felt
Make a loop out of the felt and sew it in place
A
As shown in the figure, fold the felt so that it is approximately 70 mm wide, and then sew three points (the
left, right, and center) of approximately 100 mm to form a loop.
Maintenance
277