ML-13000
User's Manual
H
Using the hex wrench (width: 2.5 mm), tighten the 12 screws that secure the scraper from the left end.
Push down on the metal plate as you tighten the screws.
I
Tighten the slide prevention screw on the right side of the scraper.
J
Push the belt cleaning unit back to its original position.
K
Confirm the message on the control panel and touch the Complete button.
The Washing Scraper counter will be cleared.
Replacing the Sponge Roller
If water droplets remain on the belt even after drying the sponge roller, replace the sponge roller with a new one.
Maintenance
227