ML-13000
User's Manual
D
Loosen the hexagonal screws on both blade supports and remove them from either side of the belt.
E
Touch the Suspended button on the control panel.
Drying the glue
Dry the glue applied to the belt.
A
Decrease the belt speed.
The speed is indicated by the arrows shown in the figure (belt speed volume: 0 to 30 degrees position).
B
Touch the Forward button on the control panel.
Rotate for two hours to allow the glue to dry.
C
Touch the Suspended - Done buttons on the control panel in that order.
D
Close the front cover and leave it for at least 8 hours to allow the glue to dry.
Confirmation after glue application
Check the condition of the glue applied to the belt.
Maintenance
337