Maintenance Menu - Epson ML-13000 User Manual

ML-13000 User's Manual

Maintenance Menu

Item
Print Head Nozzle Check
Fabric Width Saving
Print Position
Print Head Cleaning
Cleaning
Power Cleaning
Print Head Refresh
Early Maintenance/Periodic Cleaning
Cleaning the
Maintenance Parts
Belt Cleaning
Cleaning the Cleaning Tank
Adhesive Material Main-
tenance
Adding Grease to the Scan Spindle
Control Panel Menu
Parameter Description
Print a check pattern to check for clogged nozzles in the print head.
Inspect the pattern visually and perform head cleaning if you detect
On
faint or missing colors.
Setting Fabric Width Saving to On shortens the printed length of the
*
check pattern, which reduces the amount of fabric that is used.
Off
Set a position to print the check pattern in Print Position.
27 to 1000 mm
(1.06 to 39.37
inches)
Execute Print Head Cleaning. Perform Cleaning first. If clogging is not
cleared after cleaning, perform Power Cleaning until the clogging is
Left
cleared.
Execute Print Head Refresh if there are multiple large clogs even after
Right
performing Power Cleaning. When you execute Print Head Refresh,
the suction caps need to be cleaned, and because of this, the cleaning
Left
operation takes a long time, so execute it if you have the problem
described above.
Right
"Print Head Cleaning" on page 247
U
All Nozzles
Touching Early Maintenance/Periodic Cleaning will clean the heads
Select Nozzles
regardless of the timing set in Periodic Cleaning or Maintenance
Cleaning. Once implemented, the counters for Periodic Cleaning or
Maintenance Cleaning will be reset.
Flushing Pad Start cleaning the selected parts. Follow the on-screen instructions to
clean them.
Around the Head
"Inspecting/Cleaning the Flushing Pad" on page 178
U
Cleaning Pad
"Inspecting/Cleaning Around the Print Head" on page 182
U
"Inspecting/Cleaning the Cleaning Pad" on page 174
U
Suction Cap
"Cleaning the Suction Caps" on page 198
U
Encoder Scale
"Cleaning the Encoder Scale" on page 239
U
Starts belt cleaning.
Touch the Start button when cleaning the belt cleaning brushes, the
washing scraper, or the cleaning tank, or when performing flow rate
adjustment for the belt cleaning tank. Supply of water to the cleaning
tank begins.
Application Mode You are required to enter the user name and administrator password to
start glue application/removal. Follow the manual instructions to
Removal Mode
perform this.
"Removing Glue" on page 295
U
"Applying Glue" on page 316
U
Starts adding grease to the scan spindle. Follow the manual instructions
to perform this.
"Adding Grease to the Scan Spindle" on page 260
U
361