Blade Removal And Cleaning - Epson ML-13000 User Manual

ML-13000 User's Manual
c
Important:
Make sure to spray the entire belt with soapy water right after the glue runs out. If the soapy water is applied
too late, the vibrations from the blade could cause unevenness in the belt surface. Unevenness may result in
poor print quality.
A
Part with accumulated glue
B
Part without glue
E
Check that the glue accumulated in front of the blade has been completely used and soapy water is applied
to the entire belt.
c
Important:
Do not stop the belt, but ensure it continues rotating. Stopping the belt with the blade attached could cause
unevenness in the belt surface.

Blade removal and cleaning

Remove the blade that was attached to the belt and clean the blade.
A
Two people are required to lift the blade simultaneously on both left and right sides and remove it.
c
Important:
Lift the blade so that it does not come in contact with the belt. Any contact may cause unevenness on the belt
surface, resulting in poor print quality.
Maintenance
335