Table of Contents
Advertisement
As noted in Section 8.6.1, the SCI can be configured to operate in a single Synchronous mode
or one of five Asynchronous modes. Synchronous mode requires that the TX and RX clocks
use the same source, but that source may be the internal SCI clock if the SCI is configured as
a master device or an external clock if the SCI is configured as a slave device. Asynchronous
modes may use clocks from the same source (internal or external) or different sources for the
TX clock and the RX clock.
For synchronous operation, the SCI uses a clock that is equal to the two times the desired bit
rate (designated as the 2
same source for both the TX and RX clock. The internal clock is used if the SCI is the master
device and the external clock is used if the SCI is the slave device, as noted above. The clock
is gated and limited to a maximum frequency equal to one eighth of the DSP core operating
frequency (that is, 12.5 MHz for a DSP core frequency of 100 MHz).
For asynchronous operation, the SCI can use the internal and external clocks in any
combination as the source clocks for the TX clock and RX clock. If an external clock is used
for the
input, it must be sixteen times the desired bit rate (designated as the 16
SCLK
as indicated in Figure 8-6. When the internal clock is used to supply a clock to an external
device, the clock can use the actual bit rate (designated as the 1
rate, as determined by the COD bit. The output clock is continuous.
RX, TX Data
(SSFTD = 0)
x1 Clock
x16 Clock
(SCKP = 0)
When SCKP is cleared, the transmitted data on the
the serial clock and is stable on the positive edge. When SCKP is set, the data changes on the
positive edge and is stable on the negative edge. The received data on the
sampled on the positive edge (if SCKP = 0) or on the negative edge (if SCKP = 1) of the
serial clock.
clock) for both internal and external clock sources. It must use the
0
1
Idle Line
Start
Figure 8-6. 16 x Serial Clock
Serial Communication Interface (SCI)
Select 8-or 9-bit Words
2
3
4
5
6
signal changes on the negative edge of
TXD
SCI Programming Model
clock),
clock) or the 16
clock
7
8
Stop
Start
signal is
RXD
8-21
Advertisement
Table of Contents
