Setting A Central Admin Server - Fujitsu ScanSnap N1800 Operator's Manual

4.8.9 Setting a Central Admin Server

Set whether to manage the scanner under central administration.
When [Central Admin] is enabled, the scanner is registered in the Central Admin Server
as a target for central administration.
1. Select [Network Settings]
Server].
The [Scanner Central Admin Server] window appears.
ATTENTION
For Central Admin Console, [Address] and [Port Number] cannot be set.
2. For [Central Admin], select whether or not to enable Central Admin
Server.
HINT
If registration with the Central Admin Server is successful, the value for "This scanner's
server-side status is:" changes from "Unregistered" to "Registered".
Even when setting values are correct, if the network is disconnected or the Central
Admin Server is in a suspended state, registration will fail. In either case, if [Central
Admin] is [On], the process will be run again the next time the scanner is turned on or
resumed from the standby mode.
3. To enable central administration, enter the address and port number.
For [Address], enter the Central Admin Server IP address, host name, or FQDN.
For [Port Number], enter a port number to be used by the scanner to communicate
with the Central Admin Server.
4. For [Roaming Mode], select whether or not to enable roaming mode.
4.8 Configuring the Network Settings
[Network Admin]
123
Central Admin
Console
[Scanner Central Admin