I Want To Reset The Scanner To Factory Defaults - Fujitsu ScanSnap N1800 Operator's Manual

Scanner does not resume from standby mode.
■ Check item
After turning the scanner off, was the power turned back on again
immediately?
■ Action
Press the power button.
A [Scanner initialization has failed.] message appears and the scanner
does not start up.
■ Check item
Is the status the same after the scanner is turned off and then turned back on
again?
■ Action
Disconnect AC cable from the scanner to turn off the scanner, and connect the cable again. After
turning the power off, wait for at least 10 seconds before turning the power back on again.
If the problem persists even after taking the above mentioned actions, contact your FUJITSU
scanner dealer or an authorized FUJITSU scanner service provider.

■ I Want to Reset the Scanner to Factory Defaults

I want to return the scanner settings to their defaults
■ Action
Refer to "Resetting to Factory Defaults" (page
I forgot the administrator login password
■ Action
Contact your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider.
185), and reset the scanner.
402
8.3 Other Troubleshooting