Fujitsu ScanSnap N1800 Operator's Manual page 90

HINT
In the following cases, the authentication window appears.
When specifying the scanner as a domain member
When changing the name of a scanner that is a member of a domain
Check the authentication information required for specifying the scanner as a domain
member with the network administrator, and enter the valid user name and password.
User names may be up to 256 characters long.
Passwords may be up to 256 characters long. [User Name] and [Password] are case
sensitive.
If the user name and password are valid, the restart confirmation window appears.
6. Press the [Now] button.
The scanner is restarted.
HINT
Scanner names may be duplicated depending on the network status.
If the specified scanner name is the same as one already in use, network communication
problems occur.
In this case, try the following steps:
1. Disconnect the LAN cable.
2. Press the [Shutdown] button on the LCD touch panel to turn the scanner off.
3. Press the power button to start the scanner with the LAN cable disconnected.
4. Enter a non-duplicated scanner name.
5. Reboot the scanner.
6. Re-connect the LAN cable to the scanner.
The connection is lost if the scanner name is changed via the Admin Tool. To continue with
other settings, wait a short time for the scanner to restart, then access the scanner via the
Admin Tool again.
90
4.5 Configuring the System