Adjusting The Deck; Adjusting The Position Of The Roll - Canon GP605 Service Manual

4. Adjusting the Deck Registration
If the left/right registration (standard of 0
±1.5 mm) needs to be adjusted, perform the
following:
1) Slide out the compartment, and adjust the
position of the latch plate [1] of the deck
open solenoid (SL102) using the two
screws [2]. (At this time, use the scale
graduation [3] on the latch plate as a
guide.)
5.

Adjusting the Position of the Roll

If the compartment cannot be opened/
closed smoothly, requiring adjustment of the
position for the roll mounted to the front of the
deck, perform the following:
1) Remove the front cover. (See p. 10-21.)
2) With the compartment fully slid out, turn
the four mounting screws [4] on the roll
support plate [3] so that the roll [1] is
about 3mm from the floor [2]. (Use the
scale graduation [5] on the front side plate
as a guide.)
COPYRIGHT © 1999 CANON INC. CANON GP605/605V REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 10 SIDE PAPER DECK
[1] [3]
(rear left of the compartment)
Figure 10-B310
[4]
[3]
[1]
[2]
Figure 10-B311
[2]
[5]
10-31