Removing The Deck Main; Removing The Deck Lifter - Canon GP605 Service Manual

3. Removing the Deck Main Motor
(M101)
1) Detach the deck from the copier, and re-
move the six screws; then, detach the rear
cover.
2) Disconnect the two connectors [1], and re-
move the four screws [2]; then, detach the
deck main motor [3].
At this time, take care not to damage the
gear at the tip of the motor spindle.
4. Removing the Deck Lifter Motor
(M102)
1) Open the compartment of the deck, and
remove all copy paper.
2) Turn on the copier's power. If the lifter of
the deck is up, push down the sensor lever
[1] of the paper supply position sensor.
Stop the lifter [2] when it is about 7cm
from the base plate of the compartment,
and insert a hex wrench into the hole of
the lifter drive shaft [3] to hold it in place
(thereby preventing it from rotating).
COPYRIGHT © 1999 CANON INC. CANON GP605/605V REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 10 SIDE PAPER DECK
[1]
Figure 10-C303
[1]
Figure 10-C304
[3]
[2]
Figure 10-C305
[2]
[3]
[2]
[4]
10-33