Canon GP605 Service Manual page 809

<FEEDER-Related Items>
Level 3
LA- Adjusting the Original Feeding Speed for Stream
SPEED Reading Mode
STRD-S Adjusting the Scanner Stop Position for Stream
Reading Mode (small-size)
STRD-L Adjusting the Scanner Stop Position for Stream
Reading (large-size)
RVM- Adjusting the speed of Reversal Motor
SPD • For details, see the Feeder Service Manual.
<SORTER-Related Items>
Level 3
PNCH- Adjusting the offset for Punch Hole Position (feeding
HLE direction)
• For details, see the Finisher Service Manual.
COPYRIGHT © 1999 CANON INC.
Description
Stream reading scanner stop position
Lower setting Higher setting
Stream reading scanner stop position
Lower setting Higher setting
Description
CANON GP605/605V REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 13 TROUBLESHOOTING
Copyboard glass
Copyboard glass
FEEDER>ADJUST
Remarks
Range : -54 to 54 (a
higher setting will
increase the speed)
• The data is retained by
the controller PBC of
the ADF on the feeder
side.
Range : -25 to 25 (each '1'
causes a shift of 0.1 mm)
• The data is retained by
the IP PCB on the
copier.
• If you have replaced the
IP PCB or initialized the
RAM on the IP PCB,
enter the value recorded
on the service label.
Range : -30 to 30 (each '1'
increases the speed by
0.1%)
• The data is retained by
the controller PBC of the
ADF on the feeder side.
Remarks
Range : 6 to 24mm (12mm
at default)
• The data is retained by
the finisher controller
PCB on the finisher side.
13-217