Canon GP605 Service Manual page 564

CHAPTER 11 INSTALLATION
11) Check the DIP switch settings as follows:
11.1) Set SW5-3 (DIP switch) of the control-
ler to OFF.
11.2) Using the / key, indicate the settings v
v
of the DIP switches (SW1, SW5) of the
controller.
11.3) Check the settings of the DIP switches
(SW1, SW5) of the controller. (See Table
11-A601.)
If the settings are wrong, go back to "Set-
ting the Board" to make the appropriate
settings.
If you are setting the Interface Board-B1,
Interface Board-A1, or Communications
Control Board-A1 (accessories), see its
respective Installation Procedure.
11.4) Press the switch (SW2).
11-50
COPYRIGHT © 1999 CANON INC.
S1
SW1-1 SW1-3 SW1-5
SW1-2 SW1-4
: bits are at ON.
: bits are at ON.
Figure 11-C610
SW2
LED1 LED2 LED3
LED4 LED5 LED6
JC5
J5
6 1 6
SW1 ON SW5 ON
6 1
SW5-3
Figure 11-C611
CANON GP605/605V REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
S5
SW5-1 SW5-3
SW1-6 SW5-2 SW5-4
SW2
SW3
JC8
JB2
JC6
JB1
JC9
CPU
IPC
SW4
1
SW5-5
SW5-6
JA1
JA2