User Guide
4.3.2 Configuring IP Addresses by Using Network Setting Tool
4.3.2.1 Overview
Network addresses are set to a disk array for monitoring from NEC Storage Manager.
After connecting the disk array (device) to physically the same network where the machine on which
Network Setting Tool has been installed (i.e. the network not beyond a router), configure IP addresses
having the same segment as the machine on which Network Setting Tool has been installed by
referring to the example shown below.
For example:
The address of the machine on which Network Setting Tool is installed is 192.168.0.20/24.
* 1. IP addresses have the same segment as the machine on which Network Setting Tool
* 2. When the disk array and the NEC Storage Manager Client are operated on different
Release 6.0
Figure 4-14: Connect Disk Array - Example
has been installed.
segments, configure IP addresses by referring to the example shown above and then
move the disk array. When you move the disk array, make sure to remember the
gateway address settings.
108
Chapter 4 NEC Storage Manager