Setting A Time Zone Of The Disk Array; Figure 4-19: Select Disk Array Type - NEC Storage M100 Series User Manual

User Guide

4.3.3 Setting a Time Zone of the Disk Array

This section describes how to set a time zone of the disk array.
4.3.3.1 For Windows
Use NEC Storage Manager Setup to configure the time zone settings.
NEC Storage Manager Setup is automatically started when you set the NEC Storage Manager
Express Setup and Utility CD-ROM, and it allows you to perform the settings as prompted. Depending
on your environment, it may not start automatically, in which case, run the following program in the
CD-ROM.
\INSTALL\WINDOWS\ISMSETUP.EXE
Follow the steps below by using NEC Storage Manager Setup.
1. After you configure IP addresses as described in
Network Setting
Release 6.0
Tool", the page to set a time zone appears.

Figure 4-19: Select Disk Array Type

Section 4.3.2: "Configuring IP Addresses by Using
114
Chapter 4 NEC Storage Manager