Batteries; Figure 8-10: Removing The Controller Cover - NEC Storage M100 Series User Manual

Disk array unit

Hide thumbs Also See for Storage M100 Series:

Table of Contents

8.3.5 Batteries

For installing and removing the battery (BBU), follow the procedure given below:

1. Remove the controller (CONT) from its cabinet.

Section 8.3.2:

2. Remove the controller cover.

Remove the cover by sliding it while pressing the lock (circled in the illustration below).

3. Remove the battery.

Push up on the battery connector in the illustration below to remove the connector. The battery can

then be removed.

"Controllers".

Do not remove the connector while pulling a cable. Be careful about the damage of the

components by the contact.

Chapter 8 Installing Optional Parts

Storage m300 series