NEC Storage M100 Series User Manual page 42

User Guide
Label
(5) Host port
(6) Disk port
(7) USB port
(8) Ejector
Release 6.0
Description
Host ports are used to connect hosts. The port
connector form, the number of ports and the
position of LEDs to show the status vary according
to the controller type.
The disk port is used to connect to the next disk
enclosure. A controller has one disk port.
The port has a fault LED (below the port) and a link
LED (above the port).
These USB 2.0 ports are used for debugging. They
are not used under normal operation.
The ejector is used to install and remove the
controller.
42
Chapter 1 Overview