NEC Storage M100 Series User Manual page 339

User Guide
4. When logging on to the target disk array is successfully complete, the message "Logon
Succeeded." appears. Clicking OK brings you back to the logon page of the target, so click Close to
end iSCSI Setup Tool.
Release 6.0
Appendix C How to Set/Check Application Server (Windows) (iSCSI)
 iSCSI Setup Tool uses Java. It is necessary to install Java Runtime
Environment (32-bit version) to the operation server.
 The host name should be 15 bytes or less.
 An error may occur and an invalid LD set may be recorded when you
complete logon and retry to logon to a disk array system with the same
serial number. In this case, delete the invalid LD set using NEC Storage
Manager.
An application server has to be connected to both of the network

connected with a management port of a target disk array and the network
connected with a host connection port.
 When using NEC Storage Manager (NEC Storage Manager Express/NEC
Storage Manager Suite), please use the iSCSI Setup Tool in the state
which doesn't hold a configuration setting screen of NEC Storage
Manager.
 Please use the iSCSI Setup Tool in the state in which a LD set with the iqn
of the same application server does not exist in the target disk array.
 After setting an IP address in a host connection port or changing it, the
iSCSI Setup Tool will be sometimes an error. Please re-execute the iSCSI
Setting Tool in that case.
339