Table of Contents
Advertisement
User Guide
10.4.2 iSCSI Setup Tool (Linux) Errors
Problem
The message, "File not found." is
displayed.
The message, "iSCSI Initiator is not
installed." is displayed.
The message, "The parameter is
invalid." is displayed.
The message, "No parameter is set."
is displayed.
The message, "Please enter serial
number." is displayed.
The message, "Please enter target IP
address." is displayed.
The message, "Please enter the
target CHAP secret." is displayed.
The message, "The tool has already
been started." is displayed.
The message, "Invalid host name." is
displayed.
The message, "Failed to collect the
serial numbers. Error code:xxxx" is
displayed.
The message, "No management port
of the disk array is not set." is
displayed.
The message, "Host connection ports
of the disk array are not set." is
displayed.
Release 6.0
Cause and Solution
A file that is specified as a parameter file does not exist.
Specify the file name correctly.
iSCSI Initiator is not installed.
Install iSCSI Initiator, start the service, and then re-start
iSCSI Setup Tool.
The format of IP addresses of host connection ports
specified in the parameter file is invalid.
Modify the parameter file and re-start the iSCSI Setup Tool.
Valid parameters are not entered in the parameter file.
Modify the parameter file and re-start iSCSI Setup Tool.
A serial number is not entered in the parameter file.
Modify the parameter file and re-start iSCSI Setup Tool.
The IP addresses of host connection ports are not specified
in the parameter file.
Modify the parameter file and re-start iSCSI Setup Tool.
The target CHAP secret is specified but no CHAP initiator
secret is specified in the parameter file.
Modify the parameter file and re-start iSCSI Setup Tool.
The iSCSI Setup Tool is already is up and running.
Terminate the running iSCSI Setup Tool, and then restart it.
A character other than alphanumeric characters or hyphen
(-) is used for a server host name.
Change the host name using only alphanumeric characters
or hyphen (-) based on the restrictions of creating target.
After changing the host name, restart the iSCSI Setup Tool.
An error occurred in retrieving the serial number.
For details, see
Section 10.4.3: "iSCSI Setup Tool Error
Codes".
The management port settings are not configured to the
disk array.
Set the management port and start the iSCSI Setup Tool
again.
The host post connection settings are not configured.
See
Section 6.2.1: "Initialization Wizard"
initialization to configure the host connection port settings.
Then, run the iSCSI Setup Tool again.
288
Chapter 10 Troubleshooting
to perform the
Advertisement
Table of Contents
Troubleshooting
