Toro GreensPro 1200 Service Manual page 24

16 17 18
Figure 12
16 17 18
Figure 13
4. Place engine on frame. Secure engine using lock
nuts (16), cap screws (17), and flat washers (18).
19
5. Install rear support frame (19) using three lock nuts
(20), three cap screws (21), and six flat washers (22).
Gasoline Engine
20 21 22
Figure 14
23 24 25 26
6. Connect the drive coupling to the engine collar
using two nuts (23), two washers (24), two cap screws
(25), and four spacers (26).
IMPORTANT: To prevent drive coupling damage,
make sure that no distortion of coupling exists
after securing engine collar to coupling. If coupler
distortion is evident, loosen engine and reposition
engine on frame so that coupling is not distorted.
7. Install and
Transmission Cover in the Service and Repairs section
of Chapter 5 - Chassis).
8. Lower and secure the seat platform.
Page 3 - 8
Figure 15
secure transmission
GreensPro 1200
cover (see